[Valarius_Starchaser]

One areas a little long on the one side but I figure its not going to affect anything and nobody will see that area anyways so no big deal

Just worried about the dip that the bottom piece has the bolt hole in I didn't notice it because the patch didn't seem to have any alignment problems anyone have a picture of this area so that I can confirm if I did it correct or not?

By this time it was getting dark and I only had enough light to tac the other side on all in all productive not my best welds ever but my first on this thin of metal this season so good I think

Also not sure what I am going to do with those holes yet I really don't want to just fill them with rod maybe but also don't want to spend an hour making all the circles to patch them maybe a bolt head would fit nice