The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**aotte1** · 09-06-2016, 09:53 PM

John,

As mentioned about, selling our home and have been thinning stuff out, a lot. Also, was under the weather for a little bit.
Back at it now, cleaning up a bunch of bolts and brake/fuel line fasteners right now. Almost done with welding on bell housing for the NV4500 too. Hope to get the trans in before moving to new, much smaller garage!!

Brakes and brake lines next. Ordered a set of new brake line, not correct for "K" trucks, going to send originals for them to copy.

The engine is making some slow progress too.

Plan to get back posting soon, after we close on selling our home.

Thanks for asking,
Les

09-06-2016, 09:53 PM	#313
aotte1 Senior Member Join Date: Oct 2013 Location: lousiville Ky Posts: 2,637	Re: 64' K10 Project Long Bed John, As mentioned about, selling our home and have been thinning stuff out, a lot. Also, was under the weather for a little bit. Back at it now, cleaning up a bunch of bolts and brake/fuel line fasteners right now. Almost done with welding on bell housing for the NV4500 too. Hope to get the trans in before moving to new, much smaller garage!! Brakes and brake lines next. Ordered a set of new brake line, not correct for "K" trucks, going to send originals for them to copy. The engine is making some slow progress too. Plan to get back posting soon, after we close on selling our home. Thanks for asking, Les Last edited by aotte1; 09-06-2016 at 10:18 PM.