It still amazes me when I plan to knock a project out "real quick" and 8 hours later I'm still not done. But I do have more questions or am requesting more advice.
I got the rear end squared up, pan hard bar leveled out and I got the engine and transmission in the chassis. I also started building brake lines and got a lot done on them.
I need some suggestions on a vendor who is a familiar with the PB extreme drop and can build me a 2 piece driveshaft and supply the proper carrier bearing and support.
Also, does anyone make a carrier spacer for the new PB boxed trailing arm crossmember? I have an AZ Pro spacer but I didn't know when I ordered it that it's for older trailing arm crossmember and won't work with the new one.
It's really starting to look like I have been working.