Welded some square nuts on the back side of the floor support, like I've seen many others do. Will not have access to inside the rocker box when it comes time to tighten the four bolts through all these sheets of metal. Spent some time bending, shaping, fitting, welding, and grinding the floor patch. Next is the front section of the inner rocker, then kick panel, and finally, A pillar. Once that's all in, I'll be ready for the outer rocker and done with this side
__________________
-Chris
Instagram
_elgringoloco_
'70 Short-Wide How to: Ruin a perfectly good C10
‘70 Blazer ConversionHow To: Ruin a Perfectly Good 4wd
'72 Highlander How To: Ruin a Perfectly Good K/5 (SOLD)
'72 Blazer 2WD How to: Ruin a perfectly good Blazer (SOLD)
'05 Yukon Daily Driven (not so stock) Yukon (SOLD)
‘07 Yukon Denali (daily)
Members met list: SCOTI, darkhorse970, 67cheby, 67cheby'sGirl, klmore, porterbuilt, n2billet, Fastrucken, classicchev, Col Clank, GSFMECH, HuggerCST, Spray-Bomb, BACKYARD88, 5150, fine69, fatbass, smbrouss70, 65StreetCruiser, GAc10boy