[Robznob11]

The only thing I had to trim was the small felt at the bottom of the glass about 1/4" . As far as everything else you can put it in place with the glass in place. I did put the channel run in the vent before installing on one side and it's easier. But I forgot on the other side and was still able to install it relatively easy. Window down..install channel up and around. Then roll window up and install lower part. Loosen everything up to give yourself wiggle room. I used a long blunt nose screwdriver to push it in the middle and it pops right in. Just make sure not to use anything sharp and poke a hole. The whole trick to redoing these Doors is to Loosen everything so the window has room to move forward and back...hope this helps