Quote:
Originally Posted by swamp rat
Went to PT again today, then people are sadists! LOL! couple that with drilling spot welds........
Todays slicing and dicing, not done yet, but going little by little, looks like i'll have to remove a strip along the upper firewall too, not sure about the outer section where the kick panel resides just yet.
I succeeded in getting the outer floor and kick panel out from between the cab support and lower A pillar, but it was a pita! there were 2 spot welds on each outer cab support flange, very hard to get separated.
I'd like to be able to leave both the lower A pillar and the cab support in place if possible, but the only way I can clean the inside of the support is to peal back more floor. I can run a wire brush on the inside of the lower A pillar tomorrow and decide if it needs to come off. I went under the cab with a dotco and maroon pad and I cannot see or find any weak areas on front or aft supports so far.
Guess a storm front may be moving in tomorrow, Oh joy!
|
How are you planning on replacing the kick panel (I know you mentioned it a couple posts ago) with the A pillar in place? I had to remove the A pillar or drop my floor - of course, I replaced the entire floor pan and had not permanently attached it as yet, so it was kinda easy. I spent (wasted) many hours trying to figure out how to get it in there before that.