[reaper71]

These were taken from Friday afternoon.

Pic #1. After I had the floor pan all flat it didn't line up with the holes!!
Come to find out because it was so warped when it was finally flat it moved enough to make it off just enough.
So it all was taken apart and redone and this time I drilled the holes and then clamped it all together then welded the brace on.

Pic #2. In this pic you can't see it but it had a buckle to it and the weights helped take that out during the welding process,now it's ready for the inner rockers and then the quarter panel mockup.

Mark...