View Single Post
Old 01-29-2017, 10:53 AM   #21
steveo3318
Registered User
 
steveo3318's Avatar
 
Join Date: Apr 2014
Location: Sumrall, MS
Posts: 381
Re: FITECH EFI 600 Basic and Command center intall with pics, factory tank

That's 6 one way half a Dozen the other. I used the fuel command center because I have the factory behind the seat and don't care to replace it. It is brand new. Now that being said if I had thevrear tank I would of went with either an inline pump or in tank pump. Yes they are louder but don't clutter up the engine bay. In reality with the FCC I now have two points of failure instead of one. Either my mechanical pump or electric pump could die. With an in line or tank you drop the mechainical which I am all about one less item to worry about. I don't see any issues in my near future but if I HAVE to put a rear tank in I will most likely ditch the FCC and go in tank. The FCC has never given me any issues other than overheating one time and that was my fault for not lowering the idle flow parameter. Once it cooled down and I set the parameters never another issue what so ever. This info is really only based on engine bay appearance!!! I might of been saying go FCC if I had the inline pump after hearing in whine forever. I will say in tank or FCC now that I think about how loud a in line is. All three have to have the return in the end.
__________________
1967 c10 3OTT with R10 overdrive.
385 Stroker, 373 posi
FITECH EFI, Vintage air, York 210 OBA,
4/6 drop with riddler 20x8 and 20x10
1957 S5T Leslie Supertyfon train horns and EMD bell
"No bolt left unturned"
steveo3318 is offline   Reply With Quote