So we move on to phase 2 of the bed. I cut down the center section to allow if I want the sleeper attached for the center section to lift fully. I then started on the new side pieces which has an integrated wheel tub. I will make a hatch on the unfinished end to access the air ride valve and ECU. I still need to make an end plate for the wheel tub, but that's tomorrows job.
I like that these are going to be a one piece design. I did not want to weld in the wheel tubs. I want as little seams as possible. Less to seal up in the end.
Oh well at least I got a good start today.
Stay tuned!