Quote:
Originally Posted by MMcMasters
Larry,
I degreased everything then prepped the surface with 80 grit glass beed. Everything was then wiped down with wax and grease remover and sprayed with two light coats. The recommend 1mil of coverage. Just made sure the bottle was mixed good and poured directly into the gun with no thinning. It sprayed like **** but flowed out nice once it was on. 30 minute flash time between coats. I let it hang for 24 hours before I touched it. They said it is fully cured 5 days after spraying.
They also have a oven cured product but I didn't have access to an oven large enough so I went this route.
|
Thanks for the info Mike, I actually do have access to an oven and a spray booth where I work at the cabinet shop. I will have to check and see how hot the oven has to be though as we can only run ours up to about 180 or I risk setting the sprinkler system off
I really like how you set it up as bolt together it seems to make more sense to me.
