[MP&C]

This weekend we got the three hex nuts welded underneath seat bracket number two, fourth hole is a bolt through......










1/4" tall spacers fabricated to make the seat tracks level, then tacked in place on the front holes..











Prepped and hung up for epoxy primer...





OEM seat bracket holes in the floor pans open to the inside of floor crossmembers. Rather than weld them closed and warp the floor pan, we opted for these fancy hole plugs.











SPI epoxy primer applied...








When it's 39* outside and the paint booth is sucking the heat out of the building, this is how you keep the temps up to a balmy 75* in the paint booth..





We'll let the seat brackets cure for a few days and then get started on plug welding them in place..