[Moarplease]

Here is the shock before the spring is installed


Full extention. Looks longer than other I have seen with the similar kit....we'll see what happens when he's back on the ground.





Took the coil overs back off so I could lift the axle freely to check clearances as I redo the exhaust. The goal was to get the tips behind the rear wheels. I could see where the mufflers needed to be so I set to get there and see what would work. H-pipe first reusing the existing head pipes


Where the mufflers needed to be...axle is on the bumpstops


Pipes coming to the mufflers aren't exactly symetrical, but that's okay



Added an cross member from a piece of angle to place the hangers. Turned out the pipes under the frame. Placed a slip joint just inside the frame rails to removed the tailpipes for servicing requirements, over the axle, and the final piece will be added after bed is back on for ideal placement of the tips. I have added a hanger on either side axle the axle since this picture was taken



More to come....

Adam