Quote:
Originally Posted by Joe Pass
Lookin good....
|
Thank you sir.
Quote:
Originally Posted by Dieselwrencher
Nice Nova and cool project! Nice welding and fab work too. That will be a sweet ride when you guys are done with it. Do you plan to heat up the foam to get it to lay down better? I haven't tried any of that but may some time.
|
Thank you. The foam laid down fine. It also has a sticky side so it conforms to the floor where it is applied.
The MLV on the other hand was a pain! He cut it in sections and laid it down horizontally. Once it was cut to length he used a combo of heat gun, a few relief cuts, and aluminum tape to get everything in place and sealed down.