[tutone]

Ok I will give you that. I am doing the same thing on my 67 LWB and don't have the room as well. I still do not intend to remove the cab, but my cut and weld is going to be under the cab, not behind it. Some one on this board used these frame stiffeners from Early Classic Enterprises and did a nice conversion. I think about 40 bucks or so? Anyway, its the same concept as the Brothers kit, except you don't have somebody holding your hand all the way through, telling you where to drill and cut. If you have enough fabrication skill to cut and weld a frame, then you can use something like this . that is what Im going to do. the down side is relocating your back cab mount.