Re: Restoring Rusty
so after at first running out of welding wire in order to finish the driver seat, I than ran out of Argon gas to finish the passenger seat, it ain't easy folks
well here's the driver seat all mounted in, I drove it to work like this today and here's the report
these seats are narrow
the seat is tough, ie hard as a rock
I like how it slides forwards and back with the manual controls
I can't recline it all the way back cause the headrest hits the window, cause these came out of an extended cab so they can tilt further back, but I don't mind that cause I don't need it to go that far back
seat height is good, maybe a bit too tall since I used the 2x2 square tubing and maybe a 2x1 would make it an inch lower instead
|