I have been sneaking in some shop time when I can, I am still plugging away on the under dash harness.
I have some of the runs completed and the connectors installed. The ignition connector is fubar, so I just used the spade connectors on the switches terminals till I find another connector. I will put some heat shrink on them for now. The Engine Harness Connector, the Wiper Motor Connector, the Rear Light Harness Connector, the Light Switch Connector, the Dome Light Connector, and the Dimmer Switch Connector are all complete and covered with flex-braid covering.
I have the Column Connector and the Dash Harness Connector to do next.
After that I will do the Front Harness Connectors and then finish with the terminal strips for the unused circuits.
The Pate Swap Meet is this weekend at TMS, so I am headed up there tomorrow after work. I plan to be there with my boys the whole weekend. If you are there look for me, I'll be the one with a gray beard chilling under a white canopy along the fence in Zone 0, Block 200, Spaces 2066-2072.