[midniteblues]

Started loosely assembling my 8ft step bed in anticipation of getting the wack fitting beat fleetside off.

I can raise the floor with the stepper and make it fit on the dump frame easier than a fleet....plus I like the stepper look better on a 4x4.

Picked up another sport comp water temp guage since my old one went south and a small tach.
The kid has this same tach in his truck and its nice, not big and bulky.

I plan on getting the new pto cables hooked up this week I have one on allready but I gotta build brackets for the pto and dump valve.

I've been looking too build some duel's off my manifolds but wow is it gonna be tight with the pto in the way, just might be easier too put the y pipe back on.

Oh and cleaned up a oe front bumper and started putting it on. I'm thinking for now oe bumper and grill guard till I can find a winch.

Also grabbed this square body c member and skid plate this week from the jy gonna try too make it work.

I need to find some lift blocks and u bolts for the rear to level this thing out.

The 205's look good there tim.

Could a swore I was on the wdydtyttt thread...whoops