The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - TX WTB Right rear quarter panel light area

franken · 05-28-2017, 09:38 PM

If you weld that flat area its going to get strange and you'll need access to both sides to planish/stretch the metal. I think I'd be using a stud welder and pull out the dents.

05-28-2017, 09:38 PM	#13
franken Registered User Join Date: Jun 2013 Location: Somewhere Posts: 3,057	Re: WTB Right rear quarter panel light area If you weld that flat area its going to get strange and you'll need access to both sides to planish/stretch the metal. I think I'd be using a stud welder and pull out the dents.