[MP&C]

Tonight we have both seat belt retractor anchor plates welded and waiting for apprentice E to media blast and epoxy prime..








Next, we have the side filler panels to either side of the fold down rear seat that don't fit with those pesky wheel tubs in the way...








So we plan to make new ones, with a relief to fit snugly to the wheel tubs at the bottom end.. We used the Baileigh MH19 hammer and the shrinking dies to shape a piece of 14 gauge cold rolled to fit the wheel tub. Glad I didn't have to do all that shrinking by hand.














A flat piece from the top section will be welded to this piece, and then foam will be glued to the assembly and upholstered to match the seat..