I had about 2 hours this evening. I removed some of the rear outer floor and finished burning in the cab corner. My plan is to build from the outside in, from what can be seen to what is hidden by carpet, etc.
The few plug welds I got to do turned out very good, I don't think any grinding will be needed. The butt welds for seaming the patch in are another story. Grinding is very time consuming.
Lines up very good with the door. Sorry for it being rotated, it is rotated correctly in my photo editor/viewer.
My plan is to grind it down and apply some etch primer to protect it until I am done with all the patch work. Then, I'll do all the filler at once.
I'm very happy with how it turned out. I hope the rocker panel goes this smooth.