[crewadmin]

To repair the wheel I used a dremel to cut out the cracks and cleaned the area and I used JB Weld to fill my cracks. Over fill the cracks and then sand and sand some more. You will refill areas to build them up. After everything is filled and sanded I used a high build primer and sanded and primed until I was satisfied with the surface. I used an Eastwood single stage black to spray the wheel and followed that with an Eastwood 2k aero clear that leaves a very hard finish. There is no right way it is just getting in there and doing it. Both of mine have been done for 2 years and have held up very well. They are going to expand and contract and crack. I dont think anybody has a sure cure for these wheels. I will post more pics and hope this helps. Don't be reluctant to tackle it. I found it to be very rewarding!