[Possmguts]

Been a while since I updated this...

Finally got a set of headers that actually fit and got the bed wood done. Started getting the rear roll pan welded up today... should get that done tomorrow and I hope to get the EDP coating roughed up so I can get some high build on it and start blocking that out.

Was also trying to figure out how to run the SS fuel line.. one piece is gonna be a pain, so I was thinking that if I decide to go with an electric pump it would maybe be better if I split it in the middle somewhere.

Brake line are also finally all plumbed. Gotta get lines made up for the Hydraboost setup still.