[N2TRUX]

As many of you know, we did make it to Goodguys Lonestar Nationals in Ft Worth to be in the RideTech booth. Of course it was a down to the wire thrash, so allow me to share.

With the rear finished we moved back to the front. One last trip to FedEx had netted the final package with some key components for the front install.

Ridetech provides a template to cut the required holes in the crossmember for the coil over shocks to go through but I really wanted to install the mounting brackets first.

I bolted the bracket in place, and as I suspected the holes I had drilled to remove the rivets were off.
I used the RideTech bracket as a guide to align and drill the holes on center. With that done and bolts installed I scribbed inside the hole to get my cut Mark.