Quote:
Originally Posted by THE "10" SILVERADO
How easy is it to make a complete setup (hard line fitting on fuel sender all the way to carb)? Right now I've got hard lines (rusted) with simple rubber line from sender to line and line to carb at the front. I am considering doing a complete braided setup over replacing the hard lines, but I've never done a custom setup before and don't necessarily know what it entails.
|
It's fairly straightforward, I find it easier than bending hard line that's for sure.
The most challenging will be installing the hose end fittings but once you do one it will be no problem. We have installation instructions on our website.
http://www.hotrodfuelhose.com
From the sending unit you would use hardline to an6 adapter fittings. Probably 3/8 and 5/16 to AN6.
You would probably want some hose separator clamps available on the site.
As well as some P clamps to mount the hose to the frame. (Available at most hardware stores)
Then your hose bundle and you are good to go.
Let me know if you have any other questions.