Quote:
Originally Posted by botoepfer
Beautiful Family picture Indeed,, I have a few questions for you Paintman, I have a 63 C10 and I have a bad Heater core, I am looking for a bulkhead fitting to cure my AN addiction.. I too want to run braided stainless Heater lines, Also where did you get that cool Plug wire loom,,? and the cool red block for the water temp sender? Thanks Love your thread !,, all the best Bo
|
I am assuming you are refering to the stainless bulkhead fittings going through my firewall yes? I got them from Hardin Marine, they have a .com site. They were the only bulkhead fittings I could find that would match up to my heater core.
The red block that I am using for my temp. probe, I got from either Summit or Jegs. If I remember correctly