[N2TRUX]

The brake lines are complete! I wont say I hated doing it, but it was a valuable lesson in frustration. The hardest part was finding all the fittings I needed to make it work. Once those were located it was a matter of getting the bends tight enough to fit.

I learned a trick that help with the tight bends. I put a 1/2 drive extension in my bench vise to, the slid a deep socket with an extension over the fitting to use for a handle. I slowly pulled the line around the curve of the extension till I hade the bend that I needed. It took a couple of tries to perfect the technique, but it got my bends much tighter than a traditional tubing bender.