Quote:
Originally Posted by Dieselwrencher
That is looking really nice!
|
Thanks, I haven't done much on it lately, until today anyway. I started out by tack welding those side bars between the rear and middle hoops, no real drama there. Then I started working on the front stuff by drilling holes in the front floor for the foot pads to bolt down to. Once those were set I tack welded the front side bars into place. I might end up notching the passenger side tube where the glove box door hits it. I could also just trim the corner of the glove box door. Either way, it'll need a little work.
Then I made the bar to run behind the windshield frame between the 2 sides. It fit ok and leaves plenty of room to use the visors. The next piece will be the dash bar and door bars.