|
I never use the end gaskets, just permatex gasket maker (heavy oil application) for the ends and permatex gasket sealent around the water jackets only, not the intake ports. The gasket sealent is tacky and helps hold the gasket in place as you drop the intake on.
I like my holley 600 carb with eddy performer intake. If you think its fun tuning and enjoy the little bit of work that goes along with it, get a holley. If not, there is nothing wrong with a q-jet! Just make sure you make a decision before you buy the carb and intake because you have to match up the spread bore or sqaure bore intake with the carb. A lot of people bolt on square bore carbs on spread bore intakes and vise versa and are not getting the full benififs of either.
Posted via Mobile Device
|