[tmills213]

I have searched and searched and think I have this all correct now but it just felt wrong making a spacer on the trans mount. setups is the IFS xmember 6.0/4l80. the xmember would not fit turned 180 so I had to do it this way. The spacer was needed because I am measuring up 5-6 deg on the axle. with the 2 piece shaft. I understand it as I had to have the 1st shaft on the same angle (5-6 deg). With my dirty dingo mounts it needed a 2" spacer. this made the engine almost the same angle as the 1st shaft. does this seem kosher? (cross posted on FB)