Quote:
Originally Posted by Hart_Rod
Are you saying the BIM doesn't recognize the PCM? Did you update each gauge (oil, temp, speed, etc..) to get it's input from the BIM? Also, the cluster should see the PCM as long as the key is turned on.
|
no, based on the troubleshooting you can do directly on the BIM module through the basic codes and LEDS, the BIM sees and is communicating with the PCM. Its the cluster that says it does not see a PCM when I try to set it up through the ipad app.
I can get gauge readings for voltage and fuel level, but of course, both of those are independent of the PCM. I don't see anything else, but with the engine not running, they would be all at zero anyway.
If I have to take this dash apart a third time.......