07-11-2018, 04:20 PM
|
#8
|
Registered User
Join Date: May 2014
Location: ID
Posts: 663
|
Re: Did I make some OK choices?
Quote:
Originally Posted by DLW
More noob questions.
Since it looks like I will go the bridged route with passive crossovers, do I still use the HPF and LPF on the amp for anything, just SUB?
SUB only.
Set channel mode = Bridged
Level = all the way down until ready to tune?
HPF?
LPF?
Set for "Full" or "HPF"?
Bridged, FULL. Turn the levels all the way down. In bridged mode you are sending a lot of power to the speakers.
Sub woofer, top row: - Source = Ext.
- Level = low to start?
- Subsoninc = ? Woofer has a range from 20 - 250 Hz, so put it lowest? Sub has a slot-ported enclosure if that matters.
- Set to LPF?
- LPF = 80 Hz?
Yes. Ported subs should use a subsonic filter. Start at the highest setting.
Rear is not used in bridged mode right?
Check the wiring diagram in the owners manual. It uses a combo of front and rear, L/R
I also don't need to run rear pre-amp cables from HU to amp?
Nope
|
Hope this helps...
|
|
|