Re: trans fluid to radiator fitting
The guy, turns out, is a re-seller rather than the manufacturer. Still...
Looking down in the hole in the radiator, I see that there is a flare down in there ( inverted flare? ). The fitting I took off my old radiator has the corresponding flare to match that but the threads are incompatible.
This is the key:
1/2" 20 STRAIGHT THREAD G1/4
I think this means:
1/2": the bung size in the radiator for the tranny cooler
20: thread count or something to describe the threads
STRAIGHT THREAD: parallel rather than tapered thread
G1/4: again, describing the threads here I think?
However, nothing describes the properties of the flare and how to match up a fitting with it so that it seals properly.
I don't know if the fitting needs to seal at the threads, at the flare or with an O-ring.
This is not rocket science methinks. There are millions of these fittings in use right now. Surely somebody can make sense out of the above to help me determine what I need.
Thanks,
-klb
__________________
67 C10 fleet fuel injected '70 402, 700r4, 3.73 posi
07 335 sport turbo 6sp
94 Trans Am GT LT1 6sp posi -- sold after 22yrs
99 540 sport V8 6sp -- sold
73 240z L24 4sp -- given to friend
68 C10 step 350/350 3.73 open -- sold
|