This week my new old Ididit steering column arrived from Phoenix. So I got to work on finishing the power steering installation using the Ididit column and the stock 66 steering wheel. When this column was in the 62, I had a fancy wood Grant three spoke steering wheel installed. I never really liked that steering wheel. To me it was too small in diameter and had too much "dish". I like the stock 60-66 wheel more.
On Ididit's website they say the stock 60-66 steering wheel will not fit on the column they sell for the 60-66 trucks. On the phone Ididit told me that some wheels fit and some don't and to just try fitting it. Well mine fit so that is what I'm using this time.
As with the last truck I'm sticking with Ididit's telescoping intermediate shaft and u-joints at each end. No rag joint. Intermediate shaft marked for cutting and fitment -
Shaft and u-joints installed -
The engine in this truck had only a single groove crank pulley. So I picked up a new double groove pulley with an add on single groove. The PS pump uses the third groove out. Had to ditch the 1/2 inch long crank pulley bolts for some new 3/4 inch versions -
The steering box, pump and hoses were all ordered for a 73 K20. The v-belt is a Gates 36 1/8 inch belt. The belt actually could be an inch shorter. That would keep the pump reservoir cap out from under the alternator. But right now it works fine.