The transmission mount is done and in the vehicle!!!
Now on to the motor mounts. I knew I had to get the trans mount finished and the trans located perfectly in the middle of the frame before I started to mock up the motor mounts. So after the trans mount was installed I got out my lasers and levels and got the engine all centered and leveled. I then made a card board template and used it to cut out all the plate this evening.
Tomorrow (or sometime this weekend) I will get the mounts all tacked in, double and triple check all my measurements, and then finish weld everything.
I really like these fun parts of the build process. My list is getting shorter and shorter! Yeah right!!
Stay tuned!