Re: Door Mounting Plate is lost inside pillar!!
All good ideas.
Rjs53
I feel the magnet will get stuck to the first thing it contacts, probably the side of the cavity.
Jim Boy
My fenders are not on yet, so I will go at it from the engine bay side.
AussieinNC
The extra bolt May contact the hinge itself, but I think if I make the plate large enough that just might work. I’ll check measurements tomorrow when I get to working on it again.
__________________
Not Grandpa's C-20 anymore...
383 Stroker 425HP, 485Ft/Lbs
Lowered 3.5" Front / 5" Rear
66,000 miles.
Alberta, CANADA
|