Re: LS Swap/SWB Conversion Driveshaft
if your current shaft is the balloon style ends were it shrinks down to the yokes then you can not reuse them much at all . there more a 1 and done .
now if the newer one or your older one are just std tube the same dia all the way from one yoke to the other no problem . this will be easy for a driveline shop to work with .
i would also grab the rear yoke at a bare minimum for the nv3500 just to know 100% you have a yoke that fits the trans your getting .
and only have the shaft made up / modified once all your mods are done and sitting on ride height . this way you can measure for angles of yokes and length of the shaft .
3 pics i saved from doing my rear shaft on my current 4x4 build .
__________________
77-k30lb BIG truck build .
87-k30lb budget beater build .
85-k30lb the plow machine build .
85-c10sb summer fun toy .
-----------------------------
HOLLEY SNIPER efi = worst case of p.i.t.a i ever had .
EDELBROCK pro flo 4 = best deal going so far . love my setup works great.
|