[reaper71]

Update:

Hey Guys I had to switch gears a bit (need parts to finish up my radiator splash pan) so I will be moving on to my gas filler idea.

The plan is to install it into the stake pocket.
Pic 1. Here is after I made my cuts into the inside of the bed.
I mocked up the filler as well. So I cutout all of the rear panel (tube will run through here) I'll be using 1 3/4 o.d tube and will all be welded and have 1 rubber connection between the tube and tank.

Pic 2. Close up of filler (popup style)

Pic 3. Here I was figuring out the angle for the 1st tube.

Pic 4. the 1st tube welded up, this will then be welded to the next extension.

I forgot to mention, This will All be removable

Mark