Quote:
Originally Posted by rpmerf
On the fuse block, there should be a connector for IGN UNFUSED. Use this, put a fuse as close to the connection as possible, run that to the switch. 5A fuse should be sufficient, signal for the relay doesn't draw much.
|
Thanks! I currently have it wired to a in-cabin switch connected directly to the battery, as it seems the temp switch just doesn't work for some reason. My multimeter also seems to be broken, as I can't get proper measurements from it to verify the issue.
I tried putting resistors in parallel with the temp switch (started with 1k ohm down to 127 ohm), but the resistance still did not get low enough to activate the relay. I will get myself a new multimeter and measure again before I get a new temp switch. Just going to run it with a switch to IGN so that I can turn it off as needed for now.