[beaterku]

Started working on the wiring harness layout. It looks like the PSI harness is the perfect length to mount the ECU under the seat. My plan is to mount the ECM and fuse/relay panel on the passenger side. The Dakota BIM and gauge modules on the drivers side. I'd like to mount the TAC module under the seat as well. but I would have to lengthen the the harness between the TAC and pedal about a foot. The harness from the ECM is long enough to reach under the dash, so I could mount it under there. I'll just see what is the best route to take.

Fun fact, when you select NO to "OIL PRESSURE WIRING (98-02 F-BODY GAUGES ONLY)" when ordering a PSI harness, they remove the oil pressure wiring completely from the harness. Luckily, the Dakota gauges come with a sender and harness to display oil pressure. Had I known this, I would have said yes to make the wiring a little easier.