There are posts on page 16 of this thread recommending against using the '88-'98 LD 2500 spindles and rotors for 6 lug discs, due to this issue being discovered. I do not currently have an easy solution for this issue. A shorter upper control are would certainly help.
Quote:
Originally Posted by Stickboy1968
Can anyone tell me the fix to the positive camber problem that stems from using the 88-98 spindles on the 68 crossmember? I did all the steps and used the parts from the thread and my truck has HUGE positive camber without any shims. There was another thread that discussed this problem but no fix was explained. In my mind either I need to switch to 73-87 upper control arms and use the MOOG offset cross shaft to move the upper control arm inward or relocate the upper ball joint inward.
|