[JazzysC10]

Originally Posted by 67ChevyRedneck

These are old pics, but you CAN get a really good fit on the doors/fenders. I did have to rework the window frames a bit, but other than opening up a bunch of holes and using lots of shims, there was no cut/welding

This is my 67 with Goodmark (Tri-Plus) doors/fenders.









So why am I going back to GM stuff on my truck? I never could get the hood to look as good as it did with the factory fenders... it's almost like the aftermarket fenders are 1/8" "too short" at the top where they curve around. It looks good, but not as good as it could. The doors are flimsy as crap. Like really flimsy. The doors were improved the past couple of years with much thicker metal, but I've read complaints where the fit has now gone down with the thicker doors.

Looks really good. the door gaps are very uniform. When are you converting it back to GM stuff?