Quote:
Originally Posted by solidaxel
Question about the BIM.
Have you connected a scanner to your OBD2 port to verify that it works OK? Also, you need to make sure the BIM is set to read the "J" protocol. It should work regardless if the engine is running or not as long as you turn the key on.
Weare having problems with the BIM connected to the OBD the engine will start and run for a minute or two and then stalls.
Unplug the BIM and all is good.
Do you think the "J" code is the problem?
Sorry for the hijack
__________________
|
i just had the same issue on a ls swap. dakota digital has a fix. when i called they were like " oh yes, send it back" so they updated the calibration in it to fix it. said the revision 1.8 needed updated to 1.9 in the bim.
disclaimer, i expect it back tomorrow or wednsday to verify the fix.
problem was
truck ran perfect, plugging in the bim caused it to stumble randomly at idle and try to die flashing the check eng lite. un plug bim runs perfect.