Re: 1964 stepside C10 with a 6.2
im not sure how the Camaro is setup as far as driveline angle..but im betting its minimal...mine has a u-joint and hanger in the middle...so im not sure how much angle you can get by with on the rubber dampers...2 piece driveshaft is no biggie though...ill do some research on the dampers and see what I come up with..
you might contact a (good) driveshaft shop to ask this question...id suggest Dennys..extremely helpful folks there..just ask how much angle you could get out of the stock style rubbers..get a exact measurement of offset before you call....you may have to use the adapters on both ends anyway
Last edited by mongocanfly; 05-02-2019 at 05:30 PM.
|