The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Steering Wheel is a half turn off after disc brake conversion

Big John Sny · 05-20-2019, 01:40 PM

Was getting set up on the mill to machine the new locations and when I measured the locating holes on the shaft they are 17 mm (.6693"). I was thinking this was 5/8. Maybe on the older models (this front end is from a 85 suburban). I will have to order a metric end mill.
I probably should wait till I am able to remeasure the locating rivets on the cross-member.

05-20-2019, 01:40 PM	#30
Big John Sny Registered User Join Date: Feb 2014 Location: Dallas Texas Posts: 61	Re: Steering Wheel is a half turn off after disc brake conversion Was getting set up on the mill to machine the new locations and when I measured the locating holes on the shaft they are 17 mm (.6693"). I was thinking this was 5/8. Maybe on the older models (this front end is from a 85 suburban). I will have to order a metric end mill. I probably should wait till I am able to remeasure the locating rivets on the cross-member.