[sweetk30]

i would make a new bracket / mount for the sifter handle and then a pair of hiem ends and threaded rod for a new link and be done with it .

this is a bit crazy but here is my custom mount for 5 levers . i built it off the top 4 bolts for the round 6 pattern adapter to the 203 range box on the 4l80-e to 241 adapter i used for the doubler .

its just plate and 2 shifter kits from offroad design i modifyed .

#1 - pto pump in/out for hydro winch
#2 - in cab winch control
#3 - 203 range box H/N/L
#4 - rear output of 205 control H/N/L
#5 - front output of 205 control H/N/L

#6 lokar auto trans lever with linkage kit to make it work all the way up were its mounted back to the link point and then down to the trans arm .