|
Re: 1971 Stepside LS Build
Quote:
|
Did you say why you had to replace that door skin? Looks really good man. Lot of slow welding I bet. Using .023 wire?
|
The bottom outside of the door had really bad pitting. Didn't want that to show up later. The bottom of the inside was tin foiled and had about a 3/4" of putty in it. I'm using .025 wire currently.
I got the inside bottom tacked in last night. The dip on the outside at the weld is a bigger valley than what I want. Not sure where to go from here. May be starting over on this door.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021.
"I can't complain, but sometimes I still do. Life's been good to me so far."
|