The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

kipps · 07-06-2019, 02:08 PM

If I remember right, this is a small sub-harness that plugs into the main Instrument Panel harness. I "think" this harness served the accelerator and brake pedal, but I have no idea why they include "clutch" in that. I thought they did away with all manuals by this point.

Regardless, the connector shown should be identical to the one that plugs into your accelerator pedal. Check the wire colors to confirm.

All six wires can be run directly to the ECM. In the factory application, they went through the engine-to-IP connector and the IP-to-brake/clutch connector before they reached the pedal.

07-06-2019, 02:08 PM	#8
kipps Registered User Join Date: Jul 2014 Location: North-central Virginia Posts: 1,099	Re: Where do the pedal wires go? Gen IV If I remember right, this is a small sub-harness that plugs into the main Instrument Panel harness. I "think" this harness served the accelerator and brake pedal, but I have no idea why they include "clutch" in that. I thought they did away with all manuals by this point. Regardless, the connector shown should be identical to the one that plugs into your accelerator pedal. Check the wire colors to confirm. All six wires can be run directly to the ECM. In the factory application, they went through the engine-to-IP connector and the IP-to-brake/clutch connector before they reached the pedal. __________________ 1987 C6P V20 truck, 2010 LMG 5.3, AFM delete, 2010 Camaro exhaust manifolds, 1997 nv4500, 1991 np241c, hydroboost, 2005 14bff axle & driveshaft, drop-n-lock gooseneck, 4.10 gears, stock suspension, rims, and tires. Still a work in progress. Any questions or suggestions are welcome!