Re: PO has me PO'd
Installer seems to have been able to get quite a bit done, timing done with cam and crank sensors, adjusted valves, and installed poly locks correctly, working on fuel pump purchase, wiring to all sensors, and power to battery and grounds, trans. temp. ran and done, worked on mounting plenum, I was short one bolt.
Also cranked to motor over and got 60 psi up to rockers and push rods, other than the popping thru the 4 missing plugs, he said it sounded good
I lost 3 spark plug wires, in the rush to clean up basement, so the plumbers could install new soil pipe(6" cast iron to PVC)
That's about where I'm at, at the moment, still have to source out a welder to tig the ss mount to the tank, but need fuel pump first to check height
WOW, 400,000 views, seems like yesterday I started this build, it's been a great trip with all of your inputs. Best board on the net
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
Last edited by jaros44sr; 09-24-2019 at 01:18 PM.
|