Quote:
Originally Posted by Low Elco
Whoooo purdy!
|
Quote:
Originally Posted by mongocanfly
chassis looks awsome..!!!!!!
|
Thanks guys, It's always nice to hit a milestone.
I've been doing a lot of cutting, welding and grinding. The humps below the original front bench seat interfered with the bucket seats I plan to use, so I cut them out on both sides and welded in some 14ga flat sheetmetal. Then drilled and tapped some spuds to weld into the floor and the underlying supports. Had to fab up a front support on both sides as the original didn't go all the way to the tunnel. Hell for stout now, which it needs to be as the safety belt mounts are built into the seat frames.
The rear door jamb down at the rocker panel was rotted out, so I used a repro patch to repair it. Also had to fix the underlying material as well and all it needs is some seam sealer to be ready for the road. I'm also well underway with the suicide door on the driver side. The hinge portion is welded in and I'm about to finish up the surrounding sheetmetal patches.
I have a lot of small repairs to do including mods to the firewall, so October may be devoted to metal work for the most part.