The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Dakota Dig. BIM-01-2 info for Gen IV

sprint_9 · 10-30-2019, 06:59 PM

I have the exact combo you are looking at.

I cant help much on gear position as Im not utilizing the black box on the side of transmission. If your harness is stock or has that built in there is a better chance of that working. It seems to me though that on the newer ones that this info went to the bcm, but that could be wrong.

A few things I can confirm, Ive only ran through a little bit with mine as I just got it hooked up and going a couple weeks ago. I can confirm that I have water temp, oil pressure, transmission temp, and the tach through the BIM. Speed most likely works too, but cant confirm as I ran a dedicated VSS wire for speed and am using that so I have a speedometer when tuning with the obd2 port. There may be other readings that I havent ran across yet, but the important ones are there.

10-30-2019, 06:59 PM	#7
sprint_9 Registered User Join Date: Nov 2012 Location: 9 Posts: 862	Re: Dakota Dig. BIM-01-2 info for Gen IV I have the exact combo you are looking at. I cant help much on gear position as Im not utilizing the black box on the side of transmission. If your harness is stock or has that built in there is a better chance of that working. It seems to me though that on the newer ones that this info went to the bcm, but that could be wrong. A few things I can confirm, Ive only ran through a little bit with mine as I just got it hooked up and going a couple weeks ago. I can confirm that I have water temp, oil pressure, transmission temp, and the tach through the BIM. Speed most likely works too, but cant confirm as I ran a dedicated VSS wire for speed and am using that so I have a speedometer when tuning with the obd2 port. There may be other readings that I havent ran across yet, but the important ones are there.